External Control Continuous Oil Supply Pump
Feature
1. It can be applied to large capacity proportional oil supply systems
2. It is suitable for lubricating oil supply devices, as well as for a small number of lubricating oil recovery devices.
3. An externally controlled pump, and is capable of various applications according to the users' operational environments.
4. It is equipped with an ullage decrease detector.
5. Applied applied broadly from HJB series to HJC series.(Continuous type)
PUMP SPEC
| PUMP SPEC | |||
|---|---|---|---|
| MODEL NAME | HMGP-205C | ||
| PUMP TYPE | GEAR PUMP | ||
| DISCHARGE PRESSURE | 5~10kg/cm² | ||
| PRESSURE GAUGE | 0~35kg/cm² | ||
| USING OIL | 32~220(cSt) | ||
| FILTER | 80 Mesh | ||
| TANK CAPACITY | 5Liter | ||
| DISCHARGE AMOUNT | 100cc/min | ||
| INTERVAL TIME | CONSTANT | ||
| FLOAT S/W | Contact type A contact (NO) | ||
| ON at Low level | |||
| OIL SUPPLY CONTROL DEVICE | External control | ||
| OIL WARNING | Output at Contact point | ||
| MOTOR SPEC | |||
| INPUT | 25W | ||
| PHASE | 1Ø | ||
| VOLTAGE | 110V | 220V | ||
| CURRENT | 0.46A | 0.21A | ||
| FREQUENCY | 50/60Hz | ||
| PACKING SPEC | |||
| PACKING SIZE(cm) | 35(W) x 18(L) x 30(D) | ||
| WEIGHT(kg) | PUMP | 7 | |
| PACKING | 8 | ||
Components
External Figure
Operating Guide
1. It does not have a separate control device, and the pump operates automatically once power is connected and electricity is supplied.
2. The pump has to be operated repeatedly adjust on the pause time and the operation time.
3. This pump can be used with continuously operating proportional valve. But, this is not a continuous operation pump, so please refrain from operating for more than 5minutes.
4. The pump is set at 8kg/cm2 when released from the factory, but this may differ depending on the changes in the viscosities of the oils used (oil viscosity, surrounding temperature).
5. The pump is used separately like as HMGP-205S. It can be attached freely inside the tank for use
Hydraulic circuit drawing
| Wiring Diagram
|
