Internal Control or External Control Proportional Oil Supply Pump
Feature
1. It is the most suitable pump for proportional oil supply, and can be applied to a wide range of industrial fields
2. It has a simple structure and excellent durability
3. Internal control (6N) or External control (6C) are available.
4. It is equipped with a ullage decrease detector tovincrease reliability.
5. It is equipped with a dustproof device, and can be used in presses that are subjected to vibrations and impacts.
6. A line filter and a drain filter are used side by side, allowing oil reuse.
7. To fully utilize the proportional oil supply system, you must use the HJB series valve.
PUMP SPEC
| PUMP SPEC | |||
|---|---|---|---|
| MODEL NAME | HMGP-6N | HMGP-6C | |
| PUMP TYPE | GEAR PUMP | ||
| DISCHARGE PRESSURE | 16kg/cm² | ||
| PRESSURE GAUGE | 0~35kg/cm² | ||
| USING OIL | 32~220(cSt) | ||
| FILTER | 80 Mesh | ||
| TANK CAPACITY | 4Liter | ||
| DISCHARGE AMOUNT | 4~113cc | 100cc/min | |
| INTERVAL TIME | 1~120min / 1~60min / 2~32Hr | External control | |
| FLOAT S/W | Contact type A contact (NO) | ||
| ON at Low level | |||
| OIL RECOVERY | Attachable | ||
| OIL WARNING | BUZZER/LAMP | ||
| MOTOR SPEC | |||
| INPUT | 50W | ||
| PHASE | 1Ø | ||
| VOLTAGE | 110V | 200V | 220V | ||
| CURRENT | 1.15A/0.95A | 0.60A | 0.75A/0.50A | ||
| FREQUENCY | 50/60Hz | ||
| PACKING SPEC | |||
| PACKING SIZE(cm) | 35(W) x 15(L) x 30(D) | ||
| WEIGHT(kg) | PUMP | 5 | |
| PACKING | 6 | ||
Components
External Figure
Operating Guide
1. The pump operates once power is connected and electricity is supplied. You can set the pause time using the Interval ① on the front of the pump, and discharge
② to set the operating time (seconds). Afterwards, the pump will repeatedly operate and pause.
2. Minimum pause time of the pump is 1 minute, and the lowest discharge can be set to 4cc.
3. When operating the pump, the DIS, lamp ③ switches on, and during the pause, the INT, lamp ④ switches on. When ullage inside the tank decreases, the EMG lamp ⑤ switches on.
4. The MAN, button ⑥ can be used for test operations and to let air out from the pipes. (But, do not operate more than 5 minutes, as it can cause motor damage.)
5. The pump is set at 16kg/cm when released from the factory, but this may differ depending on the changes in the viscosities of the oils used soil viscosity, surrounding temperature).
Hydraulic circuit drawing
| Wiring Diagram
|
