Rock Splitter & Core Drill

Rock splitter

Non Vibration Rock Breaking Method by Powerking Rock splitter uses the multiple hydraulic pistons push the rock toward the free face side.

Work process

* Drill the hole of which diameter is bigger than 80mmØ and 1~3 meter deep by crawler drill or leg drill.

* Put the power cylinders into the holes and then push the rock toward the free face side.

* Totally 1,000~ 1,400 ton power pushes the rock for 2-4 minute and then the rock will be split.

Application

* On sites where there is a restriction or ban on the use of hydraulic impact hammers or conventional blasting methods.

* In downtown core areas where there are by laws regarding noise and dust pollution.

* Job sites near to electrical supplies, gas mains, water mains, or other services that can be adversely affected by vibration and fly rock.

* Under, in, or beside historic buildings, that can be damaged by less controlled methods.

* Excavating narrow trenches in rock, or concrete, dedicated to service lines such as gas, electricity, water and sewage.

Characteristics

* Vibration free, noise free

* Convenient Operation

*High Efficiency

* Low cost of rock breaking and maintenance

* Versatile usage

Core Drill

For drilling rock or concrete, a crawler drill (Top Hammering Drill) is generally used due to the good performance and convenience. However, this kind of drilling machine makes a lot of noise and dust.
The Excavator attached hydraulic driven diamond core drill, developed by Powerking, is a new concept machine for solving these problems.

Work process

* Install the Core Drill and connect the Hydraulic Hose line.

* Positioning of Core Drill and cleaning any loose soil.

* Water Supply.

* Open the Hydraulic Hose Line.

* Raising and Lowering of Core Bit

* Get out the remaining material

* Insert the Power Cylinder of Rock Splitter

* Secondary breaking

Application

* Drilling work of big Boulder

* Drilling work in crowd village